Bamboo-for-PlasticINDUSTRIAL DIGITAL PLATFORM
中文
◎Home ▤News ✦Q&A ▦Compare ❖Glossary ▣Data ◫Scenarios ☰About ❖ Knowledge baseFive modulesEnter →
Five Systems ↗
Enter Platform
Home/Industry Q&A/Technology & Process
TECHNOLOGY & PROCESS

How are moulded bamboo-fibre containers and trays made, and where are the control points?

SHORT ANSWER

Bamboo fibre, or a bamboo flour and fibre blend, is metered and mixed with a bio-based binder, then formed either by dry hot-press moulding or by wet pulp moulding. The control points are fibre particle size and aspect ratio, moisture content, binder ratio, and the moulding temperature and pressure curve. Moisture is the variable most often underestimated and the one that most affects yield.

The two routes are not interchangeable. Dry hot-press moulding fills a matched tool with binder-coated fibre and forms it under heat and pressure; it suits thicker trays and plates where structural strength matters. Wet pulp moulding forms a bamboo pulp web, dries it and presses it to shape; it suits thin-wall containers and lids with better surface regularity, but demands tighter control of pulp freeness.

Moisture behaves differently on each route and is the usual cause of a yield problem. Too much water flashes to steam during pressing and produces delamination, blistering and dimensional drift. Too little leaves the fibre under-plasticised and the part weak. On a running line, variation in moisture content typically costs more yield than variation in the formulation itself.

If the product is destined for the EU, the formulation has to be chosen for compliance from day one, not retrofitted. The binder and every additive must satisfy the heavy-metal and ecotoxicity requirements of EN 13432, and the grease barrier must be fluorine-free to stay inside the PPWR PFAS limits. Changing an additive later usually means re-testing food contact and re-certifying compostability — far more expensive than choosing correctly at the start.

SOURCES